Mechanical & Civil Engineering
V-Belt Length & Centre Distance Calculator
Calculate the required V-belt length and contact arc for two pulleys of known diameters and centre distance.
Your inputs
Change any value to update the result instantly.
Belt length
59.05 in
Contact arc (small pulley)
168.52 deg
Centre distance
20 in
Pulley ratio
2
What this calculator does
V-Belt Length & Centre Distance Calculator: Applies the standard machine-element relationship used in design textbooks so the capacity, rating or geometry can be worked out step by step.
What your result means
The headline figure is the capacity, rating or geometric result for the element you described. Compare it with the manufacturer's rating and your required service factor.
Formula and working
L = 2C + π(D+d)/2 + (D-d)^2/(4C)
- 1
Collect the inputs
Large pulley diameter = 8 in; Small pulley diameter = 4 in; Centre distance = 20 in
- 2
Apply the formula
L = 2C + π(D+d)/2 + (D-d)^2/(4C)
- 3
Result
Belt length = 59.05 in
Frequently asked questions
Symbols and assumptions
- D
- Large pulley diameter (in)
- d
- Small pulley diameter (in)
- C
- Centre distance (in)
- • Standard textbook geometry and steady operating conditions are assumed; shock, misalignment and wear factors are not applied automatically.
- • Material and surface-finish allowances must be chosen by the user for their actual component.
Sources and review
Reviewed 2026-09-22 · Next review 2027-09-22
- • This is an educational estimate for learning and checking, not a design deliverable.
- • Real design must follow the governing code or standard for your jurisdiction and be reviewed and signed off by a qualified engineer.
- • Safety factors, load combinations and material certification are the responsibility of the designer, not of this page.
Important limitation
This is an educational estimate based only on the values and formula shown. Verify current rates, rules, units, and professional standards before relying on the result. It is not personalized financial or investment advice.
Report a mistake or request an improvement
Tell us if a formula, unit, explanation, or result needs attention. Your message will include this calculator’s name and page.
Related calculators
Timing Belt Pitch, Tooth Count & Pulley Diameter Calculator
Compute pulley pitch diameter and required belt tooth count for a timing belt drive from belt pitch and tooth counts.
Belleville Disc Spring Stack Calculator
Estimate force and deflection for a stack of Belleville disc springs in parallel or series.
Bevel Gear Pitch Cone Angle & Thrust Force Calculator
Determine the pitch cone angle of a bevel gear pair and the resulting axial thrust force.
Helical Compression Spring Rate Calculator
Calculate the spring rate of a helical compression spring from wire diameter, coil diameter and active coils.
Helical Gear Geometry & Axial Force Calculator
Compute the normal module and axial (thrust) force generated by a helical gear from its helix angle.
Helical Spring Wahl Correction Factor Calculator
Compute the Wahl stress correction factor and corrected shear stress for a helical spring.